Add logic for saving measurement-reports from STAs.
This commit does not yet save the measurement-reports received from
clients but adds the necessary code to do so. Currently the codes can
only handle beacon-reports, but link measurements can be added to it in
the future.
It also adds the new config-key measurement_report_timeout which
controls how long measurements are saved upon they are received by a
STA.
Signed-off-by: David Bauer <mail@david-bauer.net>
Currently the min_snr option will result in kicking clients the first
time their SNR dips below.
This might not be desirable, as drivers (notably ath10k) sometimes
report a much lower RSSI for a short timeframe after returning to
sensible values. Also, a device might be in the process of roaming just
to be kicked before.
Add the min_snr_kick_delay option. A client will be kicked after this
timeframe when it's SNR is below the min_snr threshold value over the
complete timeframe.
Signed-off-by: David Bauer <mail@david-bauer.net>
Add an optional timeout when a better roaming candidate is not found
after the scan-retry limit. The roam state-machine will not retry
scanning before this timeout has expired.
If the timeout is set to 0, the client is kicked instead, which
resembles the behavior prior this commit.
This is added, as without this patch, if a forced disconnect
is not desired before roam_scan_trigger is exceeded the client will
repeatedly be asked to return active beacon-reports. For battery powered
clients this can result in a noticeable battery drain.
Signed-off-by: David Bauer <mail@david-bauer.net>
The logic for customizing the remote_node_timeout config option was
missing. The default value of 10 could not be altered by a user.
Add the required logic and a short explanation of the config-option to
the default configuration.
Signed-off-by: David Bauer <mail@david-bauer.net>
Prioritize neighbor candidates installed to hostapd. Add a new config
option to set a limit for neighbor reports installed to hostapd. This is
due to the fact, most devices will only evaluate a certain amount of
neighbor reports. Furthermore, the number of neighbor reports possible
is limited by the maximum frame size.
Signed-off-by: David Bauer <mail@david-bauer.net>
Keep track of STA journeys between multiple nodes. When a new STA is
reported from a foreign node, check whether this STA was previously
associated with a local node.
Vice versa, check upon association whether or not the STA was previously
associated with a foreign node.
Keep track of these roaming transactions using two new (local) fields of
the node struct.
Signed-off-by: David Bauer <mail@david-bauer.net>
Add a build dependency for libpcap, as it is required for the monitor
utility but not usteer itself. Use a build-dependency, as the monitor
utility executable is not packaged.
Signed-off-by: David Bauer <mail@david-bauer.net>
This adds optional support for message exchange using IPv6 multicast
messaging. This has the ability for routers and switches between nodes
to route traffic between usteer nodes multicast-aware.
By default, IPv4 is used. IPv6 can be enabled by configuring the ipv6
option to 1.
Signed-off-by: Jan Braun <keksgesicht23@gmail.com>
[squash commits - adapt usock usage]
Signed-off-by: David Bauer <mail@david-bauer.net>
