.PP
Allows you to mark a received packet basing on its IP address. This
can replace many mangle/mark entries with only one, if you use
firewall based classifier.
.PP
This target is to be used inside the \fBmangle\fP table.
.TP
\fB\-\-addr\fP {\fBsrc\fP|\fBdst\fP}
Select source or destination IP address as a basis for the mark.
.TP
\fB\-\-and\-mask\fP \fImask\fP
Perform bitwise AND on the IP address and this bitmask.
.TP
\fB\-\-or\-mask\fP \fImask\fP
Perform bitwise OR on the IP address and this bitmask.
.TP
\fB\-\-shift\fP \fIvalue\fP
Shift addresses to the right by the given number of bits before taking it
as a mark. (This is done before ANDing or ORing it.) This option is needed
to select part of an IPv6 address, because marks are only 32 bits in size.
.PP
The order of IP address bytes is reversed to meet "human order of bytes":
192.168.0.1 is 0xc0a80001. At first the "AND" operation is performed, then
"OR".
.PP
Examples:
.PP
We create a queue for each user, the queue number is adequate
to the IP address of the user, e.g.: all packets going to/from 192.168.5.2
are directed to 1:0502 queue, 192.168.5.12 -> 1:050c etc.
.PP
We have one classifier rule:
.IP
tc filter add dev eth3 parent 1:0 protocol ip fw
.PP
Earlier we had many rules just like below:
.IP
iptables \-t mangle \-A POSTROUTING \-o eth3 \-d 192.168.5.2 \-j MARK
\-\-set\-mark 0x10502
.IP
iptables \-t mangle \-A POSTROUTING \-o eth3 \-d 192.168.5.3 \-j MARK
\-\-set\-mark 0x10503
.PP
Using IPMARK target we can replace all the mangle/mark rules with only one:
.IP
iptables \-t mangle \-A POSTROUTING \-o eth3 \-j IPMARK \-\-addr dst
\-\-and\-mask 0xffff \-\-or\-mask 0x10000
.PP
On the routers with hundreds of users there should be significant load
decrease (e.g. twice).
.PP
(IPv6 example) If the source address is of the form
2001:db8:45:1d:20d:93ff:fe9b:e443 and the resulting mark should be 0x93ff,
then a right-shift of 16 is needed first:
.IP
\-t mangle \-A PREROUTING \-s 2001:db8::/32 \-j IPMARK \-\-addr src \-\-shift
16 \-\-and\-mask 0xFFFF